Clear Coat For Maple Wood

Related products options.

Clear coat for maple wood.

Most clear finishes are applied with a brush working in the direction of the grain of the wood. Our natural no stain is a clear coat that allows all the natural color grain and character of the wood to show through. Allow to dry for 2 hours allowing for shrinkage and tightening of the films to take place. Open the can of clear coat and use a stir stick to mix it up.

Be sure not to shake the can since it could form bubbles and ruin how the clear coat applies to your piece of maple. Allow each coat to dry for 20 40 minutes at 1 3 mils wet film thickness per coat. Natural clear coat no stain on soft maple wood. Another commonly used finishing technique on maple is to apply tung oil or linseed oil after the final sanding.

For a more durable finish top coat over the shellac with a clear lacquer or polyurethane. Apply a coat of finish and then tone the wood by spraying pigment on the dried finish or wiping on a gel stain. Start by sanding the surface thoroughly and wiping it down to remove any dust. Oil based polyurethane is an excellent product to use for this purpose.

Coating wood cabinetry furniture or trim with a clear finish whether you stain it or not gives it richness and depth while protecting it from knocks scrapes and the weather. Applying a clear finish to wood brings out the wood s natural beauty while sealing and protecting the wood s surface. Always apply a second coat and you may want to repeat the process with a third coat. After it dries sand lightly.

Fruitwood snw stain on hard maple wood. If desired these two options can be combined for a mix of beauty and durability. A good finish whether a clear coat or a stain gives you a chance to lock out moisture and remove the risk of rot mold or mildew. The main difference is that a clear coat does not alter the color of the wood while a stain does.

When applying polyurethane finish allow the first coat to dry overnight then sand it lightly with 220 grit sandpaper. These oils tend to bring out the curly or tiger looks of the maple. Use this guide to learn more about choosing and using polyurethane the toughest of the clear coatings. Keep stirring the clear coat until it s thoroughly mixed.

The 3 coats will melt into one another and will form a hard clear shell within 24. Most projects will be ready for normal use in 24 hours. Follow the oil with a coat or two of shellac. Then remove all the sanding dust and apply a second coat.

Most floors require two to three coats of polyurethane for adequate protection. For added durability a third coat can be applied.